Jefftron Mosfet II with Wiring

Professionally made mosfet designed for airsoft electric guns (AEG).

Device increases rate of fire and battery holds longer than with basic wiring.

Specifications:

• Presoldered wires allow faster and easier installation into the gun, it is long enough for all kinds of gel blasters. Simply cut wires to the required length and attach connectors (included in package)
• On the device are presoldered four high quality 1,5qmm (AWG16) power wires covered with MPPE insulation and two 0,34qmm (AWG22) signal wires
• Board covered by conformal coating, to protect device against water
• Designed for spring up to M210 (equivalent for current 150A single shot fire or 50A burst fire for max. 30s)
• Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipo 7.4 - 14.8V)
• 6 wires connection
• Device size 25x12x7mm
• No current consumption in the idle mode
• No sparking on switch contacts
• In auto fire mode piston stops in random position due the mechabox design
• For correct functionality it is necessary to have a functional gearbox cut off lever, selector plate, reverse latch, trigger and trigger block, within the gearbox

Device Instructions:

You can download installation manual in English here [PDF, 685.43 kB]

Recommended for installation by an experienced technician.

Package Includes:

• Device with wiring
• Deans T-plug connector male
• 30A mini fuse
• 4x faston female 2,8mm
• 6x black heat shrink tube 3,2mm - length 20mm
• 3x black heat shrink tube 4,8mm - length 20mm
• Instruction sheet